How to reconstitute peptides
Reconstituting means adding a measured amount of liquid to a powder so it can be drawn into a syringe. The outline is always the same: clean, add the liquid slowly, roll gently, check it is clear, and label the vial. The liquid and the amount come from your pharmacy or prescriber, not from this page.
Your instructions come first. A hospital guide for patients says the care team sets the procedure, and that a nurse or pharmacist tells you which liquid to use, how much, and which syringe.1 Where your instructions differ from this page, follow yours.
What you need
The hospital guide lists these supplies:1
- The vial of powdered medicine
- The vial of liquid you were told to use
- A new syringe and needle
- Alcohol pads
- A sharps container
Before you start
- Know your three numbers: the amount in the vial (mg), the amount of liquid to add (mL), and your prescribed dose.
- Check the labels. Make sure the medicine label matches your prescription.1
- Check the liquid. The label for bacteriostatic water says not to use it unless the solution is clear and the seal is intact.2
- Let a cold vial warm up if your instructions say so. One manufacturer has patients take the pack out of the refrigerator about 10 minutes beforehand.3
How to reconstitute, step by step
- Wash your hands with soap and water for 20 seconds, or use an alcohol hand sanitizer. Wipe a flat work surface clean.1
- Remove the caps from both vials without touching the rubber stoppers.1
- Clean each stopper with an alcohol pad and let it air dry. Do not blow on it or touch it afterwards.1, 4
- Pull air into the syringe equal to the amount of liquid you will draw. Push the needle through the stopper of the liquid vial and inject the air.1
- Draw the liquid. Turn the vial upside down, keep the needle tip in the liquid, and pull back to the amount you were told to use. If the needle touches anything other than the cleaned stopper, throw it away and start again with a new one.1
- Add the liquid to the powder slowly. One manufacturer's instructions say to let it run down the inside wall of the vial, so it does not land directly on the powder.3
- Take the needle out and put it straight into the sharps container.1 Never leave a needle sitting in a vial.4, 5
- Roll, do not shake. Roll the vial gently between your palms until the powder has dissolved. Shaking can damage the medicine.1, 3
- Check that it is clear. Do not use a vial that is cloudy, coloured, foamy or has particles in it. Ask your pharmacist for a replacement.3
- Write the date and time on the vial. A mixed medicine is only usable for a limited time.1
These steps come from a hospital guide for patients and from one manufacturer's instructions for its own product. They show the general technique. They are not the instructions for your medicine.
The math: what your mix means for the syringe
Once the vial is mixed, the amount of liquid you added sets the concentration:
concentration (mg/mL) = amount in vial (mg) ÷ liquid added (mL) volume to draw (mL) = dose (mg) ÷ concentration (mg/mL) units (U-100 syringe) = volume (mL) × 100
For example, by arithmetic, a 10 mg vial with 2 mL added is 5 mg/mL, so each 1 mg is 20 units. That is an illustration, not a recommendation. Enter your own numbers below.
Reconstitution calculator
Result
- Volume
- Concentration
- Doses per vial
How this was worked out
The same dose with other amounts of water
| Water | mg/mL | Units |
|---|
Arithmetic for comparison only, not a suggestion to change your mix. More water means more units for the same dose.
This is arithmetic on the numbers you entered. It does not tell you what dose to take. Confirm with your prescriber or pharmacist.
Want to save this vial and get dose reminders? Get early access
Common mistakes
- Shaking the vial. Roll it instead.1, 3
- Reusing a syringe or needle. Use a new sterile syringe and needle for each entry into a vial. A syringe is not safe to reuse even if the needle is changed.4
- Leaving a needle in the stopper between uses. It gives germs a direct route into the vial.5
- Skipping the stopper wipe on later draws. Wipe it with alcohol and let it dry before every entry.4
- Mixing up mg and mcg. They are a thousand apart. See the mcg to mg converter.
- Treating units as milligrams. See units are not milligrams.
- Not writing the date on the vial. Health guidance says an undated vial should be thrown away.4
Measuring errors do real harm. The FDA has received reports of adverse events, some needing hospital care, linked to dosing errors with compounded injectable semaglutide, including patients drawing up the wrong amount.7
Storing a vial after mixing
There is no single rule, because it depends on the medicine.
- The bacteriostatic water label says not to store mixed solutions unless the drug's manufacturer directs otherwise.2
- Limits can be short. One manufacturer requires its product to be injected within 6 hours of mixing and the rest thrown away.3
- If you were told to store the vial, store it exactly as instructed.1
We do not give a number of days or weeks, because we found no source that sets one for mixed peptides in general. Ask your pharmacy for the storage conditions and the date to discard by. For the water itself, see how to store BAC water.
Disposing of needles and syringes
- Put used needles and syringes into a sharps disposal container straight away.6
- If you do not have an FDA-cleared container, the FDA suggests a heavy-duty plastic household container, such as a laundry detergent bottle.6
- Never put loose needles in the trash or recycling, and never flush them.6
- For local drop-off options, the FDA points to safeneedledisposal.org.6
Questions
How do you reconstitute peptides?
In outline: clean your hands and the vial stoppers, draw up the amount of liquid you were told to use, add it slowly to the powder vial, roll the vial gently until the powder dissolves, and write the date on the vial. Follow the instructions from your pharmacy where they differ.
How do you mix peptides with bacteriostatic water?
The steps are the same whichever liquid you were told to use. Draw the stated amount of bacteriostatic water into a new syringe, add it slowly down the inside wall of the powder vial, and roll gently. Do not shake.
How much water do I add when reconstituting?
Use the amount your pharmacy or prescriber gave you. This guide does not set it. The amount changes the concentration, which changes how many units hold your dose.
Should I shake the vial?
No. Both the hospital guide and the manufacturer instructions we read say to roll the vial gently, because shaking can damage the medicine.
What should the liquid look like after mixing?
Clear. The manufacturer instructions we read say not to use a vial that is cloudy, coloured, foamy or has particles in it, and to ask the pharmacist for a replacement.
How long does a reconstituted vial last?
It depends on the medicine. There is no single answer. One manufacturer we read requires use within 6 hours. Follow the storage instructions and date you were given.
How do I reconstitute tirzepatide or semaglutide?
If you were prescribed a powder vial, the outline on this page applies, with the liquid and amount your pharmacy stated. If what you were given is already a liquid, it is not mixed at all, so check before adding anything.
Can I reuse a syringe to draw from the vial again?
No. Use a new sterile syringe and needle every time you enter a vial.
Does this guide tell me what dose to take?
No. It covers mixing and measuring. Your dose comes from your prescriber.
Sources
- St. Jude Children's Research Hospital, "Making liquid medicine for injection", patient education guide. together.stjude.org (opens in a new tab)
- Hospira, Inc., Bacteriostatic Water for Injection, USP, prescribing information, revised 11/2019. labeling.pfizer.com (opens in a new tab)
- Pfizer, Somavert (pegvisomant) Instructions for Use, revised July 2023. Used here as an example of a manufacturer's mixing instructions. pfizermedicalinformation.com (opens in a new tab)
- World Health Organization, "WHO Best Practices for Injections and Related Procedures Toolkit", chapter 2, 2010. Written for healthcare settings. ncbi.nlm.nih.gov (opens in a new tab)
- Centers for Disease Control and Prevention, "Preventing Unsafe Injection Practices", 26 March 2024. Written for healthcare settings. cdc.gov (opens in a new tab)
- U.S. Food and Drug Administration, "Safely Using Sharps (Needles and Syringes) at Home, at Work and on Travel", content current as of 19 November 2021. fda.gov (opens in a new tab)
- U.S. Food and Drug Administration, "FDA's Concerns with Unapproved GLP-1 Drugs Used for Weight Loss", content current as of 1 October 2026. fda.gov (opens in a new tab)
- Formulas and test cases: how the calculator math works.